**Please Note: Specs listed are for the Gen 1 XP-G LED. As per the FourSevens website Gen 2 is 20% brighter while maintaining same runtimes.**
Our current stock of Blue Preon 1s turned out a little lighter in color than the previous. They are actually a very attractive shade of lighter blue, but they don't match the "Blue" Preon accessories. Please keep this in mind if you are planning on purchasing related accessories.
Compact and absurdly bright. Three primary levels of output and three special modes of output. Lightweight and elegant. The world's first AAA powered, CREE XP-G flashlight!
Preon 1 Specifications
LED: CREE XP-G2
Max Output: 70 Out-the-front (OTF) lumens
Material: Hard-anodized Aircraft-grade Aluminum
Lens: Optical-grade glass lens with anti-reflective coating on both sides
Reflector: Light orange-peel textured
Water resistance: IPX-8
Battery: One AAA, included (see voltage range to select acceptable batteries for this light)
Operating Voltage Range: 0.9V-3.0V
Seven Output Modes:
Low: 1.8 OTF Lumens, 23 hours
Medium: 8.5 OTF Lumens, 6 hours
High: 70 OTF Lumens, 0.8 hours
Strobe 1.6 hours
SOS 2.4 hours
Beacon (Hi) 8 hours
Beacon (Lo) 40 hours
Dimensions:
Length: 2.95 inches
Diameter: 0.55 inches
Weight: 0.6 ounces
Included Accessories
Removable clip
Ring for keychain attachment
Operation
Operating your Preon 1 is simple. Make sure its batteries are inserted with the positive side (+) toward the head. Ensure the tailcap is tightened. To turn the Preon on, tighten the bezel (the ‘head’ of the light) fully down. The Preon will turn on when the bezel is fully tightened, and turn off when the bezel is loosened.
Selecting Regular Outputs
To select a different level of constant output, turn the Preon off and then on again within 1 second. This will select the next level of constant output in the following sequence:
Low -> Medium -> High
If the Preon is turned off for 2 seconds or longer, it will revert back to Low.
Selecting Special Outputs
The Preon has 4 special output modes: Strobe, S.O.S., Beacon (Hi), and Beacon (Lo). To access these modes, quickly switch through two full 'cycles' of the regular outputs, starting with Low. These two full cycles must be completed within 3 seconds:
Low -> Medium -> High -> Low -> Medium -> High -> Special Outputs
You can continue to cycle through the special outputs in the following sequence:
Strobe -> S.O.S. -> Beacon (high) -> Beacon (low)
After Beacon (Lo) mode, the output reverts back to Regular Low. Both Beacon modes will first flash 5 times and then once every 10 seconds.
This product was added to our catalog on Friday 07 October, 2011.
