m menu image  m home m cart


Exotac Replacement Wick for titanLIGHT

$5.99 CDN

 Sold Out 

Want to be notified when this product is back in stock?  Notify Me 


The wick included with the titanLIGHT should last a very long time if maintained properly.  When the wick looks worn or wispy simply pull more wick out from the top and trim with a sharp pair of scissors.  If the wick binds, you may need to remove the fuel cap and the cotton to free the wick enough to pull through.  Once you've achieved the proper length (top of the flameguard), fold the wick over between layers of cotton balls and replace the fuel cap. Each pack includes two wicks.

Replacing the wick requires patience and a sharp pair of scissors.

-Remove the flame guard by pressing out the brass pin while holding the guard down.
-Remove cotton from inside body of lighter (use a few paper towels to absorb extra lighter fluid).
-Pull old wick out.
-If necessary, clean wick hole with alcohol with a cotton swab.
-Trim the end of the new wick at a 45 degree angle with a sharp pair of scissors.
-Wet the cut end of the wick with alcohol or a small amount of water.
-While holding the cut end, pull on the opposite end of the wick to stretch it and reduce its cross-section.
-Insert new wick from the outside through the top of the lighter while being careful not to fray it.
-After wick is started into the hole, slowly guide it in in very small increments always supporting the wick with your fingers as it enters the hole.  If it does fray, trim wick and start over.
-Once you can see the wick inside the fuel cavity, grab it with a pair of tweezers or needle nose pliers and pull it through.  Leave approximately 1" protruding from the top of the titanLIGHT™ to be trimmed later.
-When replacing the cotton, you'll want to fold the wick over into the cotton to create "layers" until you get to the opening of the fuel cavity.  this maximizes the wicks surface area on the cotton so it can absorb the fuel.


  • Model: ET5535
  • Manufactured by: Exotac

This product was added to our catalog on Thursday 30 January, 2020.

Let us notify you when this product is back in stock!

Simply enter your details below and we will send you an e-mail when “Exotac Replacement Wick for titanLIGHT” is back in stock!

We will not send you any other e-mails or add you to our newsletter, you will only be e-mailed about this product!